From: Miami, Florida, U.S.A.
If that hadn't gone completely over my head I would do that, for sure.
General direction...guessing...use editor to change a component, maybe (edit: strike that)...else root around in the BaconWorld folder for updated component definitions (edit: definitely found a data table document for components and hyperdrive components have seven specific value slots, four of which are unused...but they are all at the default zero values, so if your code is accessing one of them it must be using zero for 'full effect')...
Here is my warp bubble
125, Movement - Warp Bubble Generator, 125, 0, ,23, 10, 0,1250, 65, 50, 2, 3, 0, 0,17, 4, 4, 7, 10, 5,
Note the 2,3 toward the middle. That's a 2 numerator and a 3 denominator. so the effect is to multiply the gravity well by two thirds.
These are values 4 and 5 of the 4-7 that are unused. I was looking for this in the Readme but maybe I didn't document it. It's mentioned in this thread somewhere though.