Port orientation no longer shows overlay?

[KnightHawk75]

So I noticed that the transparent 90' shading ( that showed where the elevation override would apply) that used to happen when changing the orientation of a single unit port doesn't happen anymore in the editor, is this by design? It was handy, or maybe it's only drawn when certain views or enabled now - though I tried turning everything I could think of on.

build 1147.29

[KnightHawk75]

Update:
Did this get added back in 1147.30, or was I just blind and not zoomed in enough (swear I checked that in 1147.29), in any case now it's displaying again for me in 1147.30.

[BDukes]

No through me for a loop at some point too. Just thought somebody was tinkering to improve performance.

Mike