Damage Ctrl dialog - Sensor change no-refresh (Full Version)

All Forums >> [New Releases from Matrix Games] >> Command: Modern Operations series >> Tech Support



Message


KnightHawk75 -> Damage Ctrl dialog - Sensor change no-refresh (8/7/2021 6:12:12 PM)

Issue:
Minor gui refresh issue in that updating any mount,comm & datalink, engineering/propulsion entry to another status other than it's current will change it, and update the display to indicate the change. However when updating any Sensors entry it does not auto-refresh the display.

The change itself actually does get made, a simple closing and re-opening of the window will indicate it was changed, also simply updating another component's status that is not a sensor will also refresh the window with the updated data, clicking off the changed item and back on to it will also show the status in the status drop down listed correctly, it's just the -|+ status column that doesn't update. It's easy to work around but figured it was worth mentioning.

Example with a comm link updating: [img]https://i.postimg.cc/WDhX2Xqz/Damage-Status-Datalink-Instant-Update.jpg[/img]

Example with a sensor not: [img]https://i.postimg.cc/0ztVRLQh/Damage-Status-Any-Sensor-Requires-Manual-Refresh-Or-Update-Of-Another-Comp.jpg[/img]

Repo:
1 - Insert a f-15cx (just for instance) into any scene, select Damage Ctrl.
2 - Set the link 16 comm-datalink to 'destroyed' as shown. The status above\next too it's entry it will update.
3 - Set one of the sensors to 'destroyed' as shown. The status above\next too it's entry it will not update.

Build 1147.29 (99% sure applies to .30 will check tonight tomorrow when I get around to applying it, will update post if it doesn't apply.)




michaelm75au -> RE: Damage Ctrl dialog - Sensor change no-refresh (8/8/2021 1:37:25 AM)

The issue exists in .30 too. There is a missing command to rebuild the sensor form when refreshed from the update.




Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
2.734375E-02