Bozo_the_Clown
Posts: 500
Joined: 6/25/2013 From: Somewhere else Status: offline

quote:
14.1.2. Determining Movement Point Allowances The following steps are used by the computer to determine a unit’s MP allowance during the logistics phase at the start of a turn: 1) Start with base MPs (14.1.1) 2) Calculate average fatigue of the unit based on the number and fatigue of each type of ground element. Reduce the number of MP's by the average fatigue divided by ten, rounded down. 3) Check for leader initiative. If all leaders in the chain of command fail the initiative check, then multiply MPs remaining by 80 percent, rounding down. 4) Check for leader admin. If all leaders in chain of command fail the admin check, then multiply MPs remaining by 80 percent, rounding down. Note that units that did not move in the previous turn will automatically pass their next turn's admin check. 5) Determine if fuel (motorized unit) or supplies (nonmotorized unit) is sufficient to enable the unit to use the remaining MPs it has. For example, if a motorized unit has only 50 percent of its base MPs remaining after steps 1 through 4, it will only require 50 percent of fuel needed. If fuel on hand is 60 percent of what the unit needs to use its remaining MPs, then it can only move 60 percent of those MPs, rounded down. 6) If a nonmotorized unit, reset the unit's MPs to eight if determined to be lower than eight. If a motorized unit with zero MPs, reset the unit’s MPs to one. 7) If the movement point allowance is greater than 16 and the unit is motorized, check to see if the vehicle shortage penalty applies. This penalty creates a maximum number of MPs the unit may have during the turn. For motorized units the maximum is equal to 16 + (34 * (vehicles in unit/vehicles required by unit. The maximum will never be less than 16. As an example of the above rules, a motorized Axis unit that has 80 percent of its required vehicles will start with a base MP of 50. If average fatigue were 22, then the unit MP would be reduced by 2 to 48. If all the leaders in its chain of command failed their initiative and admin checks, the unit’s MPs would be reduced first to 38 and then to 30. As 30 is 60 percent of the base MP of 50, the unit would need at least 60 percent of required supplies in order to move 30 MPs; if it had only 45 percent of its supply needs, its MPs would be lowered to 22. Since the unit has 80 percent of its vehicles, it has a maximum of 16 + (34*.8) or 43 MPs. Since the unit has only 22 MP, it is not affected further by the vehicle shortage. Had the unit had 100 percent of its fuel and had passed the leader and admin checks, instead of having 48 MPs the unit would be reduced to 43 M Thanks, Marquo. It's good to remember that fuel isn't the only deciding factor for MPs. Although, I rarely get units with less than 48/49 MPs if they have maximum fuel.
