SUB on Patrolzone won´t work fine

[Templer_12]

Sub is human set.

If I try to set a =Sub PatrolZone= there I read (not available when destination set).
Well if I never set a destination (sub standing in the same hex for a some turns) there will still be a destination set shown below =TF Destination Set=.
So I have to klick on =TF Destination Set= then right klick somewere on the map to delete the former destination below =TF Destination Set= and now I can set a sub patrol zone.

Thats the way it should be? So awkward?

Patrol Zone set on on vessel works fine. Whether there was a TF Destination set bevore.

[aprezto]

press set destination, then hit escape key. Seems to reset the destination to nothing and then you can do patrols.

[Don Bowen]

There is a know issue when TF destination is set to an at-sea hex. This is very difficult to handle since both patrol zones and waypoints cycle through a number of at-sea destinations when processing. All works fine when a destination is a base

The effect of this is minor, and it is no where near the top of the priority list.